Vertical Phone Anyphone BYOP

 

These phones are rather basic and are not capable of additional features such as BLF (Busy Lamp Field), Call Park monitoring, Call Park speed dial keys, or additional line keys.

When these phones were originally released, they were usually configured to work with an XIP (Xcelerator IP Base) unit that would provide these phones with additional features and line key options. However the XIP and these phones have long since been marked as EoL (End of Life) by the manufacturer and thus, this these phones have limited capabilities on their own.

SIP Credentials 

Before attempting to configure the phone you will first need to retrieve your SIP credentials from your telco service provider control portal. Once logged in, navigate to the “Numbers & Extensions” tab, use the search box to locate the device and then click on the DiD associated with the device. The window will change slightly and a grey menu bar will appear to the left, look for a tab that says “SIP Configuration” and click on it.

Configuration of these phones are rather simple.

The default login information is: admin/1234 or admin/22222

 

To locate the Vertical phone on the network, you can either use a network scanner, the DHCP table of the Firewall or Router, and from the phone itself via the following.

  • Config soft-key > press the down arrow until you see “Info” and press the center check mark key > use the down arrow again until you see a line that says “IP Address.”

 

Upon successful login, navigate to the SIP tab and fill in the following fields.

 

  • SIP Proxy Server: Server FQDN
  • Server port: 6060
  • Outbound Proxy Server: Server FQDN
  • Registrar Server: Server: Server FQDN
  • Registrar Outbound Server: Server FQDN
  • Registrar Server Port: 6060
  • User Name: Device Exentions
  • Phone Number: Device DiD
  • Authorized ID: SIP Authorization ID
  • Authorized Password: SIP Password
  • SIP Domain: Server FQDN
  • Place a check mark in the following 4 boxes.
    • Enable Caller ID
    • Locating SIP Server
    • End dial on #
    • Subscribe MWI
  • Voice Mail Server: Server FQDN
  • MSG Number: Device Extension
  • Click “Save Settings”

 

RTP Port 1 and RTP Port 2 > Since this phone does not have the ability to select a range, it is suggested that two ports be selected from the upper portion of the available RTP port range, however the number of phones currently on the customer’s account must also be considered. A good example would be to use ports 55001 and 55020

For the codec settings, G.729 is set by default as the First codec offered. Ensure that G.711 u-law is set to second and all other codecs are set to none.

SIP Tab

 

From the System tab, adjust the following options.

 

  • Time Zone: set this to the location that best represents where the customer is located.
  • Xcelerator IP Flag: un-check
  • Xcelerator IP Key 1 – 4 types: Set to None.
  • Click “Save Settings”

 

System Tab